General Notes

-      Replant Instructions are on product resources (linked below) on the steps to take when doing a replant.

• Products (precisionplanting.com)

-      If someone is running liquid, and they are running a consistent rate and speed through the field, then it is fully acceptable to run in Constant and take out the time to do a pump cal.

Gen 2

-      On a 2100 series planter, when getting lift state through the Case lift switch either stay on 2020.0.1, or if updating to 2020.0.4 use a Y harness (729818). Another option to get lift state is to install a push button lift switch for lift state.

2024.1.X

-      If you have growers that are going to be running .1, and they haven’t started yet, please spend some time with them and go out and make sure that they are set up and ready to go. If the system hasn’t been set up yet, it does take some vigilance and time to make sure that things aren’t missed.

-      On a vApplyHD system, we do show shaft speed if we have a shaft speed sensor. This is different from .0 where we didn’t, this is a diagnostic tool. We don’t control to a commanded shaft speed, but it is helpful when diagnosing things to know what the shaft speed is.