The Mirari Cold Plasma System represents a significant advancement in medical technology, offering a non-invasive method for treating various conditions. This article provides a comprehensive guide on how to use the Mirari Cold Plasma System effectively, ensuring that medical professionals can leverage its full potential for patient care.

Video instructions for using the Mirari Cold Plasma System

Step 1: Take the Plasma Array and plug the Magnetic Connector Cable into the Plasma Array, in the corect direction, surface with stamp facing up. When hearing a clicking sound, the Connector has correctly connected to the Array. Always ensure that the Active side shown in the picture faces the treatment area. (Figure 1)

Figure 1- Plugging the Plasma Array onto Magnetic Connector Cable

Step 2: Insert the Plasma Array in the Insulating Waterproof ePTFE  Pouch first in order to turn on Mirari Driver (NOTE: ONLY USE THE INSULATING WATERPROOF Eptfe POUCH WHEN USED IN MOUTH, OR IN CONTACT WITH WATER). (Figure 2a & 2b)

Figure 2a- Insert the Plasma Array into the Insulating Waterproof ePTFE Pouch

Figure 2b- Magnet inside the Insulating Waterproof ePTFE Pouch Latches onto the Magnetic Connector Cable

Figure 2b- Magnet inside the Insulating Waterproof ePTFE Pouch Latches onto the Magnetic Connector Cable

Step 3: Insert the Plasma Array with Insulating Waterproof ePTFE Pouch ( when using in mouth or in contact with water) or the Plasma Array , in the Insulating Fleece Pouch, then press the 2 buttons on the Insulating Fleece Pouch tightly. (Figure 3a & 3b)

Figure 3a- Insert Plasma Array in Insulating Waterproof ePTFE into Insulating Fleece Pouch

Figure 3a- Insert Plasma Array in Insulating Waterproof ePTFE into Insulating Fleece Pouch

(WHEN USING IN MOUTH OR IN THE ENVIRONMENT CONTACT WITH WATER)

Figure 3b- Insert Plasma Array into Insulating Fleece Pouch

Figure 3b- Insert Plasma Array into Insulating Fleece Pouch

Step 4: The Plasma Array is now ready to be connected to the Mirari Driver. (Figure 4)

Figure 4- Plasma Array is ready for use

Figure 4- Plasma Array is ready for use

Step 5: Plug tightly the Magnetic Connector Cable into the Mirari Driver   connector (Figure 5)

Figure 5- Plasma Driver plugged Connector into Magnetic Connector Cable

Figure 5- Plasma Driver plugged Connector into Magnetic Connector Cable

Step 6: Press the power button and hold for 3 seconds to turn the Mirari Driver “on”.   (Figure 6)

Figure 6- Press and hold the Power Button for 3 seconds

Figure 6- Press and hold the Power Button for 3 seconds

Step 7: The opening screen displays aserial number and firmware version. Click the power button again to advance to the “Home” screen. (Figure 7)

Figure 7- Press the Power Button to advance to “Home” Screen

Figure 7- Press the Power Button to advance to “Home” Screen

Step 8: Click the po