This Episodes Questions:

Brians Questions:

Hello Guys,

Love the show so much great information. I have recently got into scroll sawing. I am a comic book fan and I want to start scrolling the comic book art that I love. As you may know comic book art is very colorful. My goal is to start getting enough exotic wood to try and cover as much color as I can. In the mean time I would like to start using stain to color the woods. Are you all aware of any stains that have a good color spectrum.

Thanks

Korey from Independence KY

I am looking to build a shop building on my property. What is the minimum square footage you would recommend for a home hobbyist? I will have a miter saw, router table, table saw, and eventually a planer and dust collector. And of course a work bench with a saw vise.

I have plenty of room on my property, so that isn't a limiting factor. My biggest concern is not spending money that I don't need to on a building that is larger than needed.

What are some things you recommend that I plan for when building? Power outlet locations and qty, ceiling height, lighting type, etc.?

Thanks in advance! Kyle

Guys Questions:

I know you guys have referenced putting shellac under water based finish so you can have the richer look in the wood but ease/quick timeline of water based. I typically use an airless sprayer to apply General Finishes High Performance. I have some projects with walnut that I would normally finish with Arm-R-Seal to get the rich walnut tone. Id like to try the shellac coat first and then High Performance on top. I was wondering what is your standard application practice when you do this. Do you apply shellac (by hand or spray) and then wait a few hours/a few days/a week? Thanks for the advice and looking to avoid any pitfalls in the process being that Ive never done it before. 

Thanks and keep up the good work on the podcast.

Pete from Uncarved Block Woodworks, Madison, WI

Do you have any tips for glueing up mitered-corner boxes to ensure they are square/plumb, etc.?  I've had a hard time with this. Thanks David Vespoint

Huys Questions:

My local Rockler shut down and I found myself purchasing the Dark Half Tung oil from the real milk paint company at a steep discount. Never used the stuff but I’ve heard that dark tung oil can help give cherry a patina look without aging. I’m wondering if it can help walnut preserve its dark color over time?

Tung oil is supposed to be a pretty durable finish on it own. Have you guys tried using it as part of an arm r seal mix?

Thanks again for the help! Jose

All of my furniture pieces seem to have glue creep on all the table tops and panels. I switched from using titebond pva to titebond hide glue thinking this would solve the problem. On some newer pieces I built with the hide glue, I can now slightly feel the glue seams after a few weeks. The tops all have biscuits for alignment as well. Could this be a matter of temperature and humidity change from my shop to my house? About 40% humidity in my shop through the use of a dehumidifier. Temperature ranged from in the 50s this past winter to now it's in the 80s. Would you sand the seam lightly with 0000 steel wool or very high grit sandpaper? And any tips for future builds to avoid this again? Thanks guys! Jeff